Preparing The Cutting Units - Toro Reelmaster 5010-H Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 5010-H:
- Diagnostic manual (476 pages) ,
- Service manual (335 pages) ,
- Operator's manual (84 pages)
Table of Contents
Advertisement
Preparing the Machine (continued)
Retain the cap for later installation.
Preparing the Cutting Units
1. Remove the cutting units from the cartons.
Assemble and adjust them as described in the
cutting unit Operator's Manual.
2. Install the counterweight
end of the cutting unit as shown.
3. Grease the carrier-frame shaft
4. Repeat this procedure for the other cutting
units.
Setup: Installing the Cutting Units
IMPORTANT
G437958
to the appropriate
.
Page 3–3
G402693
G402694
3464-478 A
Advertisement
Table of Contents
