Toro Reelmaster 5010-H Operator's Manual page 17

Decal Part: 133-2931
CE Machines
Note:
This machine complies with the industry standard stability test in the static lateral and
longitudinal tests with the maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator's Manual as well as the
conditions in which you would operate the machine to determine whether you can operate
the machine in the conditions on that day and at that site. Changes in the terrain can result
in a change in slope operation for the machine. If possible, keep the cutting units lowered to
the ground while operating the machine on slopes. Raising the cutting units while operating
on slopes can cause the machine to become unstable.
Warning—read the Operator's Manual; do not
operate this machine unless you are trained.
Warning—wear hearing protection.
Thrown object hazard—keep bystanders away.
Tipping hazard—do not drive across or down
slopes greater than 15°; only drive on slopes with
the cutting units lowered; always wear a seatbelt.
Decal Part: 133-8062
3464-478A
s_decal133-2931
Warning—do not park on slopes; engage the
parking brake, lower the cutting units, shut off the
engine, and remove the ignition key before leaving
the machine.
Warning—read the Operator's Manual; do not tow
the machine.
s_decal133-8062
Page 2–10 Safety: Safety and Instructional Decals