Mounting The Finishing Kits - Toro Reelmaster 5010-H Operator's Manual

Installing the Reel Motors (continued)
4. Rotate the reel motor
the flanges encircle the bolts.
5. Torque the mounting bolts
(14 to 18 ft-lb).
6. Repeat this procedure for the other cutting
units.

Mounting the Finishing Kits

4
Parts Required
1
To ensure that the electrical cable routing is appropriate and the cables are not
twisted, mount the motors to the cutting units before mounting the finishing kits.
Center front cutting
unit
Left rear cutting
unit
1. Remove the extra flange nut as shown.
2. Loosen the nuts on the finishing kit hose fitting, insert the hose into the slot on the
bulkhead bracket, and tighten the nuts.
3464-478A
counterclockwise until
to 19 to 25 N∙m
Finishing kit (sold separately)
Right rear cutting
unit
Left front cutting
unit
G402696
IMPORTANT
G402657
Right front cutting
unit
Reel motor location
Page 3–8
Weight
Setup: Mounting the Finishing Kits