Toro Reelmaster 5010-H Operator's Manual page 66

Cruise Control (continued)
• When in transport range, press the reverse traction pedal, engage the parking brake, or
press the cruise control switch to the O
• When in mow range, press the reverse traction pedal, engage the parking brake,
disengage the PTO, or press the cruise control switch to the O
Note:
you would like to disengage cruise control but continue driving, press the traction pedal
and then disengage the cruise control for a smooth transition from cruise control to
manual speed control.
Adjusting the Cruise Control Speed
1. Enable the cruise control switch on the console.
2. Use the InfoCenter display to adjust the speed setting of the cruise control.
Indicates the cruise control
speed
Tips for Using the Cruise Control
• Set a cruising speed for long distances without many obstacles.
• On rough terrain, use the InfoCenter display to control the speed.
• Use the cruise control for turnarounds as follows:
1. While mowing, set a safe, comfortable speed for turning around at the end of mowing
passes.
2. Press the traction pedal to increase the speed for mowing during the mowing pass.
3. Take your foot off the pedal when turning around for the next mowing pass.
4. The machine will slow down to the low cruise control setting, allowing you to make an
efficient turnaround at a constant speed.
5. After turning around, use the traction pedal to increase the machine speed back up
for the next mowing pass.
Operation: During Operation
Disengaging cruise control results in the machine dynamically braking to a stop. If
position.
FF
G462143s
Indicates the maximum
traction speed (pedal stop)
Page 5–19
position.
FF
This speed is locked out
under the protected PIN
menu.
3464-478 A