Overview Of Reverse Speeds; Overview Of Displayed Traction Speeds; Overview Of The Powermatch™ System - Toro Reelmaster 5010-H Operator's Manual

Checking the Hydrostatic Braking Distance (continued)
5. Contact your Toro distributor if the stopping distance of the machine is not within 0.6 m
(2 ft) of this distance.

Overview of Reverse Speeds

Transport Reverse Speed
• If the maximum transport speed set by the supervisor is above 8.0 km/h (5.0 mph), the
maximum reverse speed is 8.0 km/h (5.0 mph).
• If the maximum transport speed set by the supervisor is at or below 8.0 km/h (5.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.
Mowing Reverse Speed
• If the maximum mow speed set by the supervisor is above 6.4 km/h (4.0 mph), the
maximum reverse speed is 6.4 km/h (4.0 mph).
• If the maximum mow speed set by the supervisor is at or below 6.4 km/h (4.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.

Overview of Displayed Traction Speeds

This machine displays estimated traction speeds in kilometers per hour (km/h) or miles per
hour (mph).
• The instantaneous speed is displayed in the upper left-hand corner of the cruise control
and virtual pedal stop screens.
• The traction speeds are estimated, and calibrated to be most accurate at 8.0 km/h (5.0
mph) while mowing. Displayed speeds are accurate when it is 0.8 km/h (0.5 mph) above
or below the display speed while driving on dry, flat pavement.
• Contact your authorized Toro distributor if the machine's observed speeds deviate more
than 2.4 km/h (1.5 mph) from the displayed speeds.
Overview of the PowerMatch™ System
Additional horsepower is supplied on-demand from the 48-VDC battery pack and is
managed by the PowerMatch system. This additional battery power is intended for short
periods of time—not for continuous or sustained periods at maximum horsepower.
PowerMatch is made up of 2 different processes:
Overview of Powershed Mode
When the horsepower requirement is greater than the 24.8 hp of the engine, the generator
will gradually reduce charge to the batteries and the 48-VDC battery pack will start driving
the reels. This is transparent to the operator. The generator is shedding its power
requirement from the engine, and the available engine horsepower can go to the traction
hydraulics.
Operation: Before Operation Page 5–15 3464-478 A