Table of Contents
Advertisement
7
Preparing the Cutting Unit
for Use on an eFlex Machine
Parts needed for this procedure:
1
Target plate
1
Weight rod (supplied with your traction unit)
1
Flange-head bolt (supplied with your traction unit)
Installing the Target Plate
•
If you will be using the cutting unit on an eFlex
traction unit, install the provided target plate, then
adjust the machine sensors as described in the
eFlex traction unit Operator's Manual.
•
If you will be using the cutting unit on
gasoline-powered machines, you do not need the
target plate.
•
If you will be using the cutting unit on both gasoline
units and the eFlex machines, you can install the
target plate and leave it installed regardless of
which machine you use it on.
1.
Setup and prepare the cutting unit as described
in the cutting unit Operator's Manual.
2.
Remove the center, grass-shield bolt
13).
3.
Install the target plate to the top of the cutting
unit (under the plastic cowling) using the bolt
you removed previously
(Figure
(Figure
13).
1. Center, grass-shield bolt
Installing the Weight Rod
1.
Enlarge the lower hole on the right side of the
cutting unit using a 9 mm (23/64 inch) drill bit
(Figure
14).
2.
Lubricate the O-ring on the weight rod.
3.
Insert the O-ring end of the weight rod into the
previously drilled hole.
9
Figure 13
2. Target plate
Figure 14
g017294
g026123
Advertisement
Table of Contents
