Important Product Information; Use As Prescribed - Siemens SIMOGEAR BA 2330 Operating Instructions Manual

Introduction
1.6 Important product information
1.6

Important product information

1.6.1

Use as prescribed

Note
The motors are part of the geared motors. Geared motors, in the sense of the current EC
Machinery Directive 2006/42/EC and the UK directive "Supply of Machinery (Safety) Regulations
2008", are partly completed machines for installation into machinery or other partly completed
machinery, equipment or plants.
Based on the area of validity of these directives, commissioning is prohibited until it has been
absolutely identified that the end product is in conformance with these directives.
The motors have been designed for stationary use in general mechanical engineering
applications.
They comply with the harmonized standards of the series EN 60034 (VDE 0530). They are not
approved for operation in hazardous zones and areas.
Unless otherwise agreed, the motors are intended for use in machines, other incomplete
machines or equipment and systems in the industrial environment.
The motors have been fabricated based on state-of-the-art technology and are shipped in an
operationally safe condition. Changes made by users could affect this operational reliability
and are forbidden.
Note
The data on the rating plate assumes an installation altitude of up to 1 000 m above sea level.
The permissible ambient temperature is stamped on the rating plate.
In the case of other ambient temperatures and installation altitudes, contact Technical Support.
The motors have been designed for the applications described in Chapter Technical data
(Page 105). Do not operate the motor outside the specified power limit. Other operating
conditions must be contractually agreed.
Do not use degrees of protection ≤ IP54 outdoors. Air-cooled versions are designed for
ambient temperatures of ‑20 °C to +40 °C as standard and for an installation altitude of up to
1 000 m above sea level. Observe and comply with deviations to the data on the rating plate.
Conditions at the location of use must comply with all specifications on the rating plate.
Do not climb on the motor. Do not place any objects on the motor.
12
Motors for mounting onto SIMOGEAR gearboxes
Operating Instructions, 01/2024, A5E53220841A/RS-AA