Table of Contents
Advertisement
Innovative Hearth Products
Superior
DRT/DRC3500 Series Direct-Vent Gas Fireplaces
TM
Install the Hood
20.
NOTE: All models must have a hood installed prior to operation.
1. Install the hood by sliding it into the slots on the lower edge of the cabinet top.
NOTE: To install the non-combustible finish material flush with the top of the hood, the hood must be installed
before installing the finish material. If finish material is installed flush with the top edge of the hood, the hood cannot
be removed.
NOTE: To install the hood after installing the non-combustible finish material over the black surface above the
fireplace opening, the bottom edge of the finish material must be 5/8" above the top edge of the hood to allow
clearance for installation and removal of the hood.
Reinstall the Included Barrier
21.
Reinstall any barrier removed before operating the fireplace. The barrier is designed
to reduce the risk of burns from hot glass. Do not operate the fireplace without the
barrier installed.
NOTE: All models must have a barrier installed prior to operation.
1. Open the control compartment door (Page 53).
2. Hold the barrier in front of the glass door and slide it up into the slots above the glass door and under the hood.
3. Slide the barrier bottom down into the slots below the glass door, securing it in place.
Install the Finishing Materials
22.
1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished wall, position framework to accommodate the thickness
of the finished wall.
Figure 39: Combustible Wall Framing
NOTE: See Cold Climate Insulation on Page 10 and Vent Termination Clearances on Page 13.
Attach the Safety-in-Operation Warning Labels
23.
1. Attach the furnished safety instruction labels at all fireplace operation and control points (Page 45).
NOTE: The installer MUST ensure these warnings are properly attached during installation. The warning labels are a
critical means of informing consumers of safe operation practices.
44
WARNING
This Area
Must Remain
Clear of
Combustible
Materials
1" Min.
Combustible
(25 mm)
Finished Wall
Materials
Stand Off
Must Be Bent
To Vertical
Position
Standoff
Provides
Space From
Combustible
Top Of
Materials
Appliance
4" Clearance
Minimum
Hood
900298-00, 10/2014
3"
(76 mm)
Installation
Advertisement
Table of Contents
