Setting Communications With The Pc Using Memory Switches - Omron NT30C-ST141-E Operation Manual

Setting Communications with the PC Using Memory Switches

3-5 Setting Communications with the PC Using Memory
Switches
Memory Switches
Reference
[ INITIALIZE MEMORY MENU ]
Quit
Screen Memory
Memory Table
History Data
Initialize History Data?
Yes
• If no is selected instead of Yes, the NT30/30C returns to the Initialize Memory
Menu without initializing the memory.
Upon completion of display history data initialization, the NT30/30C returns to
the Initialize Memory Menu.
The NT30/30C can be connected to a PC by the Host Link or NT link. The link can
be selected by setting the memory switch. Also, the Host Link baud rate, auto-
matic reset function, RS-232C communication conditions, etc. are set with the
memory switches.
This section describes the communications condition settings by using the
memory switches.
The NT30/30C has the memory areas used to store the PC connection method,
communications conditions, system settings, etc. that can be used as the
switches and called the memory switches. Since the memory switch settings are
backed up by battery, they are not lost when the power is turned OFF.
If the memory switch data is not backed up by the built-in battery, it will all be
initialized to the values set with the NT-series Support Tool when the NT30/30C
is switched OFF.
If the message "Battery Lowered" is displayed while the NT30/30C is operating,
replace the built-in battery immediately. For details on how to replace the bat-
tery, see Replacing the Battery (page 253).
Select "History Data."
Select "Yes."
The display history data
memory is initialized.
No
Section 3-5
83