Creating And Transmitting Screen Data; Creating Screen Data - Omron NT30C-ST141-E Operation Manual

Creating and Transmitting Screen Data

4-1

Creating and Transmitting Screen Data

4-1-1 Creating Screen Data

Screen Data Creation Method
116
This section describes briefly the NT-series Support Tool settings required for
creating screen data and the screen data creation procedure. Screen data must
be created to use the NT30/NT30C
For the details of the NT-series Support Tool and screen data creation, refer to
the NT-series Support Tool for Windows Operation Manual (V061). There are
some differences in the displays depending on the version.
The screen data is created by using the NT-series Support Tool. The NT-series
Support Tool registers the screen data used with one NT30/30C to one file.
Screen data can be created by one of the following three methods:
• Creating a new file;
• Editing an existing file to create a new.
The same screen data can be used for both the NT30 and NT30C. Also, NT-se-
ries Support Tool for Windows can be used to convert screen data from the
NT20S, NT620C, or NT625C for use with the NT30 or NT30C. Refer to the NT-
series Support Tool for Windows Operation Manual for information on convert-
ing screen data between different PT models.
NT-series Support Tool for Windows can read screen data created on the DOS
version of the NT-series Support Tool. You can also import individual scenes,
components, or tables from screen data files. Refer to the NT-series Support
Tool for Windows Operation Manual for details.
Section 4-1