Omron NT30C-ST141-E Operation Manual page 178

Numeral Setting
Numeral setting
cursor moving key
Reference
166
S Specifying the Column Using Numeric Keys
The numeral setting input column is specified with the HOME,
keys out of the numeric keys. A cursor can be moved between the numeral set-
ting input columns using these keys as shown below.
→
6563
HOME
4568
←
5107
When the HOME key is pressed, the cursor can be moved at a stretch to an
area at the upper left corner where a sum of XY coordinates is at a minimum
(the numeral setting input column at the upper left in the example above).
S Specifying the Column Using the System Keys
When the system keys
the order that the numeral setting input column is created by the NT-series
Support Tool.
For example, when three numeral setting input columns are created, a cursor
can be moved in due order as follows:
key: First ! Second ! Third ! First
key: First ! Third ! Second ! First
The order of movement using the system keys
ged. For details, refer to NT-series Support Tool for Windows Operation Manu-
al (V061).
S Specifying the Column Using the Cursor Moving Keys
With the numeral/character string setting cursor moving key of the touch switch
being set, the numeral setting input column can be specified only by touching
the key.
1234
Pressed
5678
9012
S When using NT-series Support Tool, cursor moving keys can be automatically
created as touch switches associated with the input fields when numeral set-
ting input fields are created.
S The pop-up window function (open) can also be assigned to the cursor moving
keys (if the keys are created automatically, this function can be set by modifi-
cation).
3200
↑
0000
↓
4624
and of the touch panel, a cursor can be moved in
Position to
be entered
Section 4-8
, , ,
and can also be chan-
Position to
1234
be entered
is moved.
5678
9012