Omron NT30C-ST141-E Operation Manual page 73

Connection to a PC by the NT Link
60
DIP Switch Setting for C200HX/HG/HE(-Z), CQM1, CQM1H
With the C200HX/HG/HE(-Z), CQM1, and CQM1H, in order that the PC Setup
settings (data memory) are enabled, set the DIP switch on the front panel in the
way shown below.
C200HX/HG/HE(-Z) CQM1
RS-232C Port Communications Conditions Setting
Set SW5 to OFF to enable the settings made in PC Setup.
DIP Switch Setting for CPM2A
With the CPM2A, in order that the PC Setup settings (data memory) are
enabled, set the DIP switch on the front panel in the way shown below.
DIP Switch Setting for CPM2C
With the CPM2C, in order that the PC Setup settings (data memory) are
enabled, set the DIP switches on the front panel in the way described below.
Set the DIP switch according to the way the peripheral port
and the RS-232C port are used.
• If (1) the PT is connected to the peripheral port or (2) the PT is connected to the
RS-232C port and a device that requires communications settings other than
the standard settings is connected to the peripheral port, set the DIP switches
in the way shown below.
• If the PT is connected to the RS-232C port and a Programming Console is
connected to the peripheral port, set the DIP switches in the way shown below.
Section
CQM1H
Set the communications
setting switch to OFF
(down position).
Set SW1 to OFF.
Set SW2 to ON.
Set SW1 to OFF.
Set SW2 to OFF.
2-7