Installing The System Program - Omron NT30C-ST141-E Operation Manual

Installing the System Program

2-4

Installing the System Program

Reference
Model Number
NT30-ZS3PC-EV1
NT30-ZS3DV-EV1
NT-ZJCMX-EV4
Reference
22
S Communication Conditions
Communication conditions are set when the NT-series Support Tool is started.
S Recommended Connecting Cable
Use the cables indicated below.
CV500-CN228 (length: 2 m), made by OMRON
(D-sub, 9-pin, male ↔ D-sub, 25-pin, male)
XW2Z-S001 (conversion cable), made by OMRON
(D-sub, 25-pin, female ↔ Half-pitch, 14-pin, male, used together with the
CV500-CN228)
XW2Z-S002 (length: 2 m), made by OMRON
(D-sub, 9-pin, male ↔ D-sub, 9-pin, female, for IBM PC/AT or compatible
computer)
To make a connector cable, refer to the appendix Connecting Cable Specifica-
tions (page 281).
With the NT30/NT30C, the system program is not fixed and can be installed (or
re-installed). This means that the system program can be easily replaced when
grading up or changing the system configuration.
S If the system program is erased, it will become completely impossible to use
the NT30/NT30C without reinstalling the system program. Before erasing the
system program, confirm that the System Installer and the system program
are at hand. Screen data and memory switch settings, however, will be saved.
The following software is used to install the system program.
S System Installer
Communications Method
Host Link
NT Link (1:1) NT Link (1:1)
Host Link
NT Link (1:1)
S The system program that is included in the NT30-ZS3jj-EV1 is installed in
the NT30/NT30C at the time of delivery.
S All of the system programs and System Installers required for the
NT30/NT30C are provided with the NT-series Support Tool for Windows
(Ver. 4).
A simple explanation of the system program installation method is given here.
For a detailed explanation about setting up System Installer on a computer and
System Installer operations, refer to the manual provided with the System
Installer.
S Installing the System Program
Install the system program onto the NT30/NT30C using the following procedure.
(1) Initialized the NT30/NT30C
If another system program is already installed, erase that system program
first.
With the power supply to the NT30/NT30C turned OFF, turn ON DIP switch
(SW2) pin 7 and then turn ON the power supply. When the confirmation mes-
sage is displayed, execute erasing the system program
Section
Remarks
Installed in the NT30-ST131(B)-EV1/
NT30C-ST141(B)-EV1 at the time of NT30C-ST141(B)-EV1 at the time of
delivery.
For Windows
2-4