Installing The System Program - Omron PC CONNECTION - 04-1997 Operation Manual

Installing the System Program

1-2 Installing the System Program
Reference: Since NT20S and NT600S already have a dedicated system program written into
In order to use an NT30/NT30C or NT620S/NT620C in a multi-vendor system, a
dedicated system program must be installed in the PT using the "NT series system
installer" shown in the table below.
Model
NT30-ZS3AT-EMV1
NT620-ZS3AT-EMV1
For details on how to operate the system installer, refer to its instruction manual, or
the PT Operation manual.
them, this installation is not required for them. However, some PT models cannot
be used in multi-vendor systems: check the situation for the model used by refer-
ring to "1-1 Possible Combinations" (page 1-2).
Applicable PC
Mitsubishi A series
Mitsubishi FX series
Mitsubishi A series
Chapter 1-2
1-3