Table of Contents
Advertisement
8.5 Control commands
Teach-in
The currently measured brightness value will be accepted as
the brightness setpoint value. It is possible to select which
zones are to be taught in.
L If constant lighting control is activated in one zone, the
taught-in brightness setpoint value is adopted for the
<presence> status.
Automatic night mode
If the night mode (detection of motion/presence in absolute
darkness) is not needed, the power consumption can be redu-
ced by deactivating night mode.
– Switching on and off
L Night mode can also be activated and deactivated in the
ETS application.
Programming mode
– Switching on and off
– Activated programming mode must always
be deactivated manually.
Test mode
– When the test mode is activated, the number
of persons to be simulated can be entered. A distinction
is made between motion and presence.
– Each zone can be tested individually.
Factory settings
The presence detector is supplied with a factory setting. This
factory setting can be restored at any time.
Firmware update
One can manually search for a firmware update.
L In general, the system automatically searches for the
firmware update. If a new update is available, a pop-up
window appears.
8.6 Zones
– Add and edit 6 zones, which
can be labelled.
– An exclusion zone can be added to each zone to
suppress sources of interference.
– Zone configurations can also be transferred
to other thePixa devices.
L When creating the zones, make sure that walls, windows
and large screens are not in the zone. Exclusion zones can
be included as an aid.
8.7 Info
– List with information on hardware and software.
– In addition, the safety mode can be
switched on and off.
Create a (new) background
image
Transfer zone configuration to
another detector
Edit zones
Add exclusion zone
Add zone
Info
Switch safety mode
on/off
8
Advertisement
Table of Contents
