Theben thePixa P360 24V KNX UP WH Manual page 6

IMPORTANT: The following must be observed
during start-up ...
Create a background image with
†
Add or edit zones.
†
Enter or check the following parameters:
†
— Perform temperature calibration (if necessary)
— Perform brightness calibration for each zone!
— If necessary, adjust installation height, sensor sensitivity
and room definition.
Overview
Menu navigation is via a slider located in the upper area of
the screen:
Grid – occupancy – heat map – parameters –
control commands – zones
8.1 Grid
.
Show and hide zones
Create a (new) back-
ground image
The motion/presence detected by the presence detector is
displayed in green (motion) and red (presence).
L Various algorithms are stored in the presence detector
for different types of changes. This can lead to a motion/
presence being displayed for a short time longer than it
actually exists. This means that those objects are dis-
played that are also forwarded to the KNX unit.
8.2 Occupancy
Graphical display of occupancy rate and occupancy density of
the past 7 days, for each zone individually:
— Occupancy rate: zone occupancy per hour in %
— Occupancy density: zone utilisation per hour in %
8.3 Heat map ("thermal image")
– Graphical display of the recorded motions over a
defined period of time. (export as a .csv file possible).
– Up to 24 heat maps can be stored
and called up.
Show and hide zones
Detail settings/export/
delete
Selection of stored heat
maps
6