Lenovo 7Y45 Instructions Manual page 28

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPWD0004I Watchdog Timer interrupt occurred for [WatchdogElementName].
FQXSPBR4001I Running the backup Management Controller [arg1] main application.
FQXSPCA0007J Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
FQXSPCA0015J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPEA0003J Link down is detected on port [arg1] of the PCIe device [arg2].
FQXSPEM4040I Dust filter measurement is completed. The airflow pathway is
obstructed, check and replace the dust filter, or remove any
obstructing object.
FQXSPEM4043I A [arg1] failure has been detected and need [arg2] to recover.
FQXSPIO4001I GPU Board Status was changed by [arg1] of [arg1].
FQXSPMA0010J [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
FQXSPMA4034G Health of DIMM [arg1] is in warning state and sub-state is [arg2].
FQXSPNM4010I DHCP[[arg1]] failure, no IP address assigned.
FQXSPNM4032I DHCPv6 failure, no IP address assigned.
FQXSPPP4009I The measured power value exceeded the power cap value.
FQXSPPU0002G The Processor [ProcessorElementName] is operating in a Degraded
State.
FQXSPPW0003G Failure predicted on [PowerSupplyElementName].
FQXSPPW0006I [PowerSupplyElementName] has lost input.
FQXSPPW0031J Numeric sensor [NumericSensorElementName] going low (lower non-
critical) has asserted.
FQXSPPW0057J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPPW0101J Redundancy Degraded for [RedundancySetElementName] has
asserted.
FQXSPPW0104J Non-redundant:Sufficient Resources from Redundancy Degraded or
Fully Redundant for [RedundancySetElementName] has asserted.
FQXSPPW4002I Total graphics power value has exceeded the pre-configured limit.
FQXSPSD0002G Failure Predicted on [StorageVolumeElementName] for array
[ComputerSystemElementName].
FQXSPSE0000F The Chassis [PhysicalPackageElementName] was opened.
FQXSPUN0009G Sensor [SensorElementName] has asserted.
FQXSPUN0018J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPUN0026G Device [LogicalDeviceElementName] has been added.
FQXSPUN0056G Sensor [SensorElementName] has asserted.
24
ThinkSystem ST250 Messages and Codes Reference
Severity
Informational
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning