Lenovo 7Y45 Instructions Manual page 149

Messages and codes reference
Hide thumbs Also See for 7Y45:
Table of Contents

Advertisement

Attempt to flash the XCC firmware to the same level on all nodes.
• FQXSPUP4005I: FPGA firmware mismatch between nodes/servers [arg1] and [arg2]. Please
attempt to flash the FPGA firmware to the same level on all nodes/servers.
A mismatch of FPGA firmware has been detected between nodes/servers
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0133
User Action:
Attempt to flash the FPGA firmware to the same level on all nodes.
• FQXSPUP4006I: Auto promote primary XCC to backup is [arg1] by user [arg2] from [arg3] at IP
address [arg4].
Auto promote primary XCC to backup is enabled or disabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0281
User Action:
Information only; no action is required
• FQXSPUP4007I: Violation access to XCC SPI flash is detected and isolated.
This message is for the use case where violation access to XCC SPI flash is detected and isolated.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0298
User Action:
Information only; no action is required
• FQXSPUP4008I: Violation access to UEFI SPI flash is detected and isolated.
This message is for the use case where violation access to UEFI SPI flash is detected and isolated.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0299
User Action:
Information only; no action is required
.
Chapter 2
XClarity Controller events
145

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinksystem st2507y46

Table of Contents