Lenovo 7Y45 Instructions Manual page 138

• FQXSPSE4089I: The chassis node with node ID [arg1] is inserted.
This message is for the use case where node is inserted into the chassis.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0337
User Action:
Information only; no action is required
• FQXSPSE4090I: The chassis node with node ID [arg1] is removed.
This message is for the use case where node is removed from the chassis.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0338
User Action:
Information only; no action is required
• FQXSPSR0001N: Sensor [SensorElementName] has transitioned to non-recoverable from a less
severe state.
This message is for the use case when an implementation has detected a Sensor transitioned to non-
recoverable from less severe.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Hard Disk drive
SNMP Trap ID: 5
CIM Prefix: PLAT CIM ID: 0524
User Action:
Complete the following steps until the problem is solved:
1. Check Lenovo Support (http://support.lenovo.com/) for service bulletins and Tech tips
2. Update the firmware for your drive.
3. Look for RAID-related errors.
4. Replace the identified drive and rebuild the array.
5. If the prolem persists contact service support.
• FQXSPSR2001I: Sensor [SensorElementName] has deasserted the transition to non-recoverable
from a less severe state.
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable from less severe has deasserted.
Severity: Info
Serviceable: No
134
ThinkSystem ST250 Messages and Codes Reference