Lenovo 7Y45 Instructions Manual page 15

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPEM4030I A scheduled operation on the RAID controller has encountered an
issue. Refer to RAID Logs under Server Management, Local Storage,
for details.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4031I SSD wear threshold setting is changed from [arg1] to [arg2] by user
[arg3] from [arg4] at IP address [arg5].
FQXSPEM4032I Acoustic Mode [arg1] has been engaged. Fan speed limits are in
place.
FQXSPEM4033I Acoustic Mode [arg1] has been disengaged to allow adequate
cooling.
FQXSPEM4036I Dust filter measurement schedule is configured on server [arg1] by
user [arg2] from [arg3] at IP address [arg4].
FQXSPEM4037I Attempting to perform scheduled dust filter measurement on server
[arg1].
FQXSPEM4038I Dust filter measurement schedule is disabled on server [arg1] by user
[arg2] from [arg3] at IP address [arg4].
FQXSPEM4039I Attempting to perform an immediate dust filter measurement on
server [arg1] by user [arg2] from [arg3] at IP address [arg4].
FQXSPEM4041I The SmartNIC in slot [arg1] encountered boot timeout.
FQXSPEM4042I The SmartNIC in slot [arg1] went through a crash dump.
FQXSPEM4044I Dust filter measurement was successfully completed, no action is
needed.
The bare metal connection process has been started.
FQXSPFC4000I
FQXSPFC4001I The bare metal update application reports a status of [arg1].
FQXSPFC4002I System running in setup.
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot.
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc.
FQXSPFC4005I UEFI deployment boot mode has been disabled.
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
FQXSPFW2000I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPFW2001I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPFW2002I The System [ComputerSystemElementName] has recovered from a
firmware hang.
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName].
FQXSPIO2001I The connector [PhysicalConnectorElementName] configuration error
has been repaired.
FQXSPIO2002I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
.
Chapter 2 XClarity Controller events
11