Lenovo 7Y45 Instructions Manual page 154

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFPU0023I Secure Boot Image Verification Failure has been cleared as no failure
in this round boot.
FQXSFPU0025I The default system settings have been restored.
FQXSFPU4034I TPM Firmware recovery is finished, rebooting system to take effect.
FQXSFPU4038I TPM Firmware recovery successful.
FQXSFPU4041I TPM Firmware update is in progress. Please DO NOT power off or
reset system.
FQXSFPU4042I TPM Firmware update is finished, rebooting system to take effect.
FQXSFPU4044I The current TPM firmware version could not support TPM version
toggling.
FQXSFPU4046I TPM Firmware will be updated from TPM1.2 to TPM2.0.
FQXSFPU4047I TPM Firmware will be updated from TPM2.0 to TPM1.2.
FQXSFPU4048I A request was made to update the TPM 2.0 firmware to version
1.3.2.20.
FQXSFPU4049I TPM Firmware update successful.
FQXSFPU4080I Host Power-On password has been changed.
FQXSFPU4081I Host Power-On password has been cleared.
FQXSFPU4082I Host Admin password has been changed.
FQXSFPU4083I Host Admin password has been cleared.
FQXSFPU4084I Host boot order has been changed.
FQXSFPU4085I Host WOL boot order has been changed.
FQXSFSM0007I The XCC System Event log (SEL) is full.
FQXSFSR0002I [arg1] GPT corruption recovered, DiskGUID: [arg2]
FQXSFDD0001G DRIVER HEALTH PROTOCOL: Missing Configuration. Requires
Change Settings From F1.
FQXSFDD0002M DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
FQXSFDD0003I DRIVER HEALTH PROTOCOL: Reports 'Reboot' Required Controller.
FQXSFDD0005M DRIVER HEALTH PROTOCOL: Disconnect Controller Failed. Requires
'Reboot'.
FQXSFDD0006M DRIVER HEALTH PROTOCOL: Reports Invalid Health Status Driver.
FQXSFDD0007G Security Key Lifecycle Manager (SKLM) IPMI Error.
FQXSFMA0029L The [arg1] PFA Threshold limit has been exceeded on DIMM [arg2].
[arg3]
FQXSFMA0076M DIMM [arg1] is not supported, DIMM identifier is [arg2].
Hardware physical presence is in asserted state.
FQXSFPU0021G
FQXSFPU0022G The TPM configuration is not locked.
FQXSFPU0023G Secure Boot Image Verification Failure Warning.
150
ThinkSystem ST250 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning