Lenovo 7Y45 Instructions Manual page 155

Messages and codes reference
Hide thumbs Also See for 7Y45:
Table of Contents

Advertisement

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFPU0024G
Intel UEFI ACM startup failed, make sure TPM is enabled.
FQXSFPU4033F
TPM Firmware recovery is in progress. Please DO NOT power off or
reset system.
FQXSFPU4035M
TPM Firmware recovery failed. TPM chip may be damaged.
FQXSFPU4040M
TPM selftest has failed.
FQXSFPU4043G
TPM Firmware update aborted. System is rebooting...
FQXSFPU4045G
Physical Presence is not asserted, abort TPM Firmware upgrade.
FQXSFPU4050G
Failed to update TPM Firmware.
FQXSFPU4051G
Undefined TPM_TCM_POLICY found
FQXSFPU4052G
TPM_TCM_POLICY is not locked
FQXSFPU4053G
System TPM_TCM_POLICY does not match the planar.
FQXSFPU4054G
TPM/TCM card logical binding has failed.
FQXSFPW0001L
CMOS has been cleared.
FQXSFSM0002N
Boot Permission denied by Management Module: System Halted.
FQXSFSM0003N
Timed Out waiting on boot permission from Management Module:
System Halted.
FQXSFSM0004M
An XCC communication failure has occurred.
FQXSFSR0001M
[arg1] GPT corruption detected, DiskGUID: [arg2]
FQXSFSR0003G
The number of boot attempts has been exceeded. No bootable
device found.
FQXSFTR0001L
An invalid date and time have been detected.
FQXSFDD0004M
DRIVER HEALTH PROTOCOL: Reports 'System Shutdown' Required
Controller.
FQXSFIO0011M
A PCIe parity error has occurred on Bus [arg1] Device [arg2] Function
[arg3]. The Vendor ID for the device is [arg4] and the Device ID is
[arg5]. The Physical slot number is [arg6].
FQXSFIO0012M
A PCIe system error has occurred on Bus [arg1] Device [arg2]
Function [arg3]. The Vendor ID for the device is [arg4] and the Device
ID is [arg5]. The Physical slot number is [arg6].
FQXSFMA0001M
DIMM [arg1] has been disabled due to an error detected during POST.
[arg2]
FQXSFMA0002M
An uncorrectable memory error has been detected on DIMM [arg1].
[arg2]
FQXSFMA0003K
A memory mismatch has been detected. Please verify that the
memory configuration is valid. [arg1]
FQXSFMA0004N
No system memory has been detected. [arg1]
FQXSFMA0005N
Memory is present within the system but could not be configured.
Please verify that the memory configuration is valid. [arg1]
FQXSFMA0008M
DIMM [arg1] has failed the POST memory test. [arg2]
Severity
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Error
Error
Error
Error
Error
Error
Error
Error
Error
.
151
Chapter 3
UEFI events

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinksystem st2507y46

Table of Contents