Advertisement
3.3.3 Disassembly and Reassembly of the Leaf Screen Filter Assembly
Disassembly
1. Using Figure 5 as a guide, grasp the frame with your thumbs on the handles at the corner
of the assembly and pull outward in opposite directions to separate the frame at the
corner. Continue to open the frame (it will pivot at the opposite corner) until the outer
screens and grid can be removed from the frame.
Step 2 - Separate
the outer screens
and grid.
Figure 5
2. Separate the outer screens and grid.
Cleaning
1. Clean the two frame pieces, outer screens, and grid using a good quality degreaser
and hot water from a spray nozzle. The groove in the seal frame pieces can be
cleaned with the edge of a Scotch-Brite™ or similar cleaning pad.
2. At each scheduled boil-out, disassemble the leaf filter assembly and place in the
frypot being boiled out. Follow the boil-out procedure in Section 4.4.1 of this manual.
3. Allow all filter assembly components to air dry or thoroughly dry with clean towels
before reassembling.
Step 1 - Grasp frame with
thumbs on these handles and
pull frame apart at corner.
3-8
Advertisement
