Advertisement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device
may not cause harmful interference, and 2) This device must accept any interference received, including interference
that may cause undesired operation. While this device is a verified Class A device, it has been shown to meet the Class B
limits.
This digital apparatus does not exceed the Class A or B limits for radio noise emissions as set out by the ICES-003 standard
The Commonwealth of Massachusetts requires any and all gas products to be installed by a licensed plumber or pipe
fitter.
Adequate means must be provided to limit the movement of the appliance without depending upon the gas line
connector and the quick-disconnect device or its associated piping to limit the appliance movement.
All fryers equipped with casters must be stabilized by installing restraining chains. If a flexible gas line is used, an
additional restraining cable must be connected at all times when the fryer is in use.
All fryers equipped with casters must be installed using a connector that complies with the Standard for Connectors for
Moveable Gas Appliances, ANSI Z21.69 or CSA 6.16, and a quick-disconnect device that complies with the Standard for
Quick-Disconnect Devices for Use with Gas Fuel, ANSI Z21.41 or CSA 6.9.
No warranty is provided for any Frymaster fryer used in a mobile or marine installation or concession. Warranty protection is
only offered for fryers installed in accordance with the procedures described in this manual. Mobile, marine or concession
conditions of this fryer should be avoided to ensure optimum performance.
The front ledge of the fryer is not a step! Do not stand on the fryer. Serious injury can result from slips or contact with the hot
oil.
Do not spray aerosols in the vicinity of this appliance while it is in operation.
When installed, this appliance must be electrically grounded in accordance with local codes, or in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code, CSA C22.2 applicable, or the appropriate national
code of the country in which installed.
When installed, this appliance must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA54, or the Natural Gas and Propane Installation Code, CSA B149.1 as applicable or the appropriate national
code of the country in which installed.
The filter pan must be emptied and cleaned at the end of frying operations each day. Some food particles can spontaneously
combust if left soaking in certain shortening material.
Do not bang fry baskets or other utensils on the fryer's joiner strip. The strip is present to seal the joint between the fry
vessels. Banging fry baskets on the strip to dislodge shortening will distort the strip, adversely affecting its fit. It is designed
for a tight fit and should only be removed for cleaning.
NOTICE
U.S.
CANADA
of the Canadian Department of Communications.
NOTICE
DANGER
NOTICE
DANGER
DANGER
DANGER
DANGER
DANGER
WARNING
Advertisement
