Table of Contents
Advertisement
Receiver modulation select ( RX ): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize S-FHSS or FHSS setting in RX during transmission.
Note that you have to turn your transmitter off and back on before a modulation change becomes effective. Be sure you
S-FHSS / FHSS
NOTE: When you change models in MODEL SELECT , if the new model is set to the other modulation type,
to remind you until you do so. See p. 27, MODEL SELECT , for details.
R2008SB
Use
by
GOAL of EXAMPLE:
Change model 1 from S-FHSS to FHSS .
Where next?
F/S ) settings as you intended (see p. 48).
Adjustability:
• S-FHSS
number of channels.
• FHSS
S-FHSS
mode. Because,
STEPS:
Confirm you are currently using the
proper model memory (Ex: 1)
Open the menu, then open PARAMETER
submenu.
Go to RX and change setting.
Cycle power.
Now that the model is in the proper modulation, the T8J should communicate
Change MODEL TYPE to airplane/helicopter: see p. 30.
Set F/S settings for when 2.4G receiver sees interference: see p. 48.
Utilize servo REVERSE : see p. 35.
Adjust servo travel with END POINT : see p. 36.
Set up dual/triple rates and exponential ( D/R , EXP ): see p. 39.
S-FHSS mode/ FHSS mode)
FHSS
has channel restrictions.
31
INPUTS:
On home screen, check model name and
number on top left and the modulation
on top right. If it is not the correct
model, use MODEL SELECT , p. 27.
for 1 second.
to PARAMETER .
to RX .
to FHSS .
cycle power
Cycle power.
Advertisement
Table of Contents
