Switch Assignment Table - FUTABA T8J FUT01004369-3 Instruction Manual

SWITCH ASSIGNMENT TABLE

• The factory default functions activated by the switches and VR for an 8J Mode 2 transmitter are shown
below.
• Most 8J functions may be reassigned to non-default positions quickly and easily.
• Basic control assignments of channels 5-8 are quickly adjustable in AUX-CH .
• Note that most functions need to be activated in the programming to operate.
• 8J Mode 1, 8JH, and 8J transmitter functions are similar but reverse certain switch commands. Always
check that you have the desired switch assignment for each function during set up.
Switch/VR
A or H
SWITCH A
SWITCH B
SWITCH C
SWITCH D
SWITCH E or G*
SWITCH F or H*
SWITCH G or E*
SWITCH H or F*
VR
*On the 8JA Mode 2 transmitters, the TOP LEFT SWITCHES are spring-loaded and 2-position; on the 8JA Mode 1, 8JH, those
switches are on the right side. For consistency, the switch position's designation remains the same (upper left is F, etc), but the
functions are moved to match the switch type.
TO TURN ON THE 8J SYSTEM
First make sure the throttle stick is in the low throttle position.
*If the throttle stick is not in the low position,
you'll have an alarm until the stick is in the low position.
Airplane ( ACRO )
elevator dual rate
rudder dual rate
up = ELE-FLP on
center/down = IDLE-DOWN
down = AIRBRAKE on
aileron dual rate
landing gear/ch 5
snap roll/trainer
none
none
FLAPERON on)
Helicopter ( HELI )
elevator dual rate
rudder dual rate
governor
aileron dual rate
throttle hold/ch5
trainer/ THR-CUT
idle-up 1 and 2
idle-up3/gyro
CH8
Push up to turn on.
13