Table of Contents
Advertisement
PARAMETER submenu: sets those parameters you would likely set once, and then not disturb again.
Once you have selected the correct model you wish to work with, the next step is setting up the proper parameters for this
(ACRO)
(HELI)
MODEL TYPE : sets the type of programming used for this model.
The T8J has 20 model memories, which can each support:
• one powered aircraft ( ACRO
elevator servos, ELEVON , and V-TAIL for further information.)
(Each model memory may be set to a different model type.) If your transmitter is a T8JA, the default is ACRO . If it is a
HELI(H1) .
ACRO is the best choice for most powered airplanes:
• ACRO adds:
• SNAP-ROLL
• AILEVATOR (twin elevator servo support)
MODEL TYPE
GOAL of EXAMPLE:
Select the proper MODEL TYPE for your
model. Ex: ACRO .
[NOTE: This is one of several functions
• What type is the receiver's modulation [ S-FHSS or FHSS ]?
• Does the model have a normal throttle on channel 3 or do you need full range
trim on channel 3 ( ATL )?
using the MODEL RESET : see p. 28.
IDLE-DOWN , THR-CUT , THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.
MODEL TYPE
STEPS:
O p e n t h e m e n u , t h e n o p e n t h e
PARAMETER submenu.
Go to MODEL TYPE .
Select proper MODEL TYPE .
Ex: ACRO .
MODEL TYPE for details, p. 30.
30
MODEL TYPE
INPUTS:
for 1 second.
to PARAMETER .
to TYPE .
to ACROBATIC .
Sure? displays.
for 1 second.
Advertisement
Table of Contents
