Entering A Setup Code - Sherwood VR-758 User Manual

FUNCTION TABLE of the NUMBERED BUTTONS
Device to be
controlled
(for TV)
TV
Button symbol
POWER ON
1
REPEAT
2
A<>B
3
VOLUME
4
MUTE
5
CH SEL.
6
TUNING
7
8
0 9 +10
9
10
STEP/
11 PAUSE
Notes:
• Some functions for each component may not be available or may work differently.
• Depending on other kinds of components that are available for each DEVICE button, some functions may not be available or
may work differently, too.
• For details about functions, refer to the operating instructions of each component.

ENTERING A SETUP CODE

• This remote control can control up to 4 different components.
• Before operating video components other than this unit with using this remote control, the setup code for each component
should be entered.
Turn on the component you want to control
1
Press and hold down both the ENTER
button and the DEVICE button you want for
3
more than 1 second.
POWER
AUDIO
DVD
TV VCR CBL SAT
TV
ADJUST/CH LEVEL VOLUME
PARAMETER D. RANGE CH SEL.
MUTE
PL
CLEAR REPEAT A< >B DSP MODE
ANGLE PROGRAM RANDOM
STEREO
PROGRESSIVE
T.SEARCH NTSC/PAL PBC SCAN VCR
SUBTITLE AUDIO
TITLE ZOOM
SETUP MENU
CBL
ENTER
DISPLAY RETURN
PRESET
STEP/ ENTER
TUNING PAUSE INPUT
SEL.
SAT
DIMMER SLEEP T.TONE
+10
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL RM-107
• The LED will flicker once.
Note:
• The AUDIO/DVD button is unavailable for the
components other than this unit.
Repeat the above steps 1 to 4 for each of
your components.
5
(for VCR)
CBL
VCR
: For TV
: For VCR
: For cable box
: For satellite receiver
11
(for cable box) (for satellite receiver)
SAT
Find the setup code according to the type and
the brand name of your component, referring to
2
"Setup Code Table" on page 64.
Enter a 3 digit code, aiming the remote
control at the remote sensor on the
4
component.
Example) When entering "001".
POWER AUDIO
DVD
TV VCR CBL SAT
ADJUST/CH LEVEL VOLUME
PARAMETER D. RANGE CH SEL. MUTE
PL
CLEAR REPEAT A< >B DSP MODE
ANGLE PROGRAM RANDOM
STEREO
T.SEARCH NTSC/PAL PBC PROGRESSIVE
SCAN
SUBTITLE AUDIO
TITLE ZOOM
SETUP MENU
ENTER
DISPLAY RETURN
PRESET
0
STEP/
TUNING PAUSE INPUT
SEL.
DIMMER SLEEP T.TONE
+10
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL RM-107
• If entering is performed successfully, the LED will flicker
twice.
• To be sure that the setup code is correct, press the
POWER button. If your component is turned off, the setup
code is correct.
• When your component is not turned off, repeat the above
steps 2 to 4, trying each code for your component until
you find one that works.
Notes:
• If the LED did not flicker twice, then repeat the above
steps 3 to 4 and try entering the same code again.
• Manufacturers may use different setup codes for the
same product category. For that reason, it is important
that you check to see if the code you have entered
operates as many controls as possible. If only a few
functions operate, check to see if another code will work
with more buttons.
0 1