Sherwood VR-758 User Manual page 18

Continued
Refer to the previous page and adjust the speaker settings.
Note: When the SPEAKER button is set to off, the speaker setting function cannot be available.
Select the desired speaker setting mode.
1
Main unit
SPEAKER
At the desired setting mode, select the
desired setting.
2
Main unit
ADJUST
or
When the speaker size setting mode is selected
• In case of front, center and surround speaker size setting mode
(L )S(
• In case of subwoofer setting mode
Y
When the speaker distance setting mode is selected
0.3 0.6 .......
Repeat the above steps 1 and 2 until the speaker setting are all adjusted.
3
Memorize the speaker settings you adjust.
4
Main unit
MEMO/ENTER
MODE
RC
ADJUST/CH LEVEL
N)
N
8.7 9.0
RC
ENTER
or
19
• Each time this button is pressed, the speaker setting
mode changes in succession and its current setting
flickers for several seconds as follows :
FRONT L 3.3 M 3.3 M CNTR L 3.3 M
SUBWOOFER-Y 1.8 M SURR L 1.8 M
• L: Large, S: Small, N: No or None, Y: Yes,
M: Meters, CNTR: Center, SURR: Surround
• When the speaker size is set to "N", "--" is displayed
instead of the distance and its distance setting
mode cannot be selected.
• When the speaker setting mode disappears, press
the SPEAKER MODE button repeatedly to select
the desired mode.
• Depending on the speaker setting modes, each time
these buttons are pressed, the setting changes as
follows :
• At the front speaker size setting mode, "N" cannot
be selected.
• When the front speaker size is set to "S", the center
and surround speaker sizes cannot be set to "L".
• You can adjust the distance within the range of
0.3~9meters in 0.3 meter intervals
• The speaker settings you adjust are stored in the
memory.
3.3 M