Using Functions Of Remote Control; Entering A Setup Code - Sherwood RD-8500 Operating Instructions Manual

USING FUNCTIONS OF REMOTE CONTROL

• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup code for each
component should be entered.
• For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD
player, "DVD" for Sherwood DVD player and "AUX" for Sherwood tape deck respectively as its factory setup code. So, you
don't need to enter its code for each Sherwood component except in such a case that its code does not work.

Entering a setup code

Turn on the component you want to control
1
Press and hold down both the ENTER
3
button and the DEVICE button you want
for more than 1 second.
T/V T/V
• The LED will flicker once.
Note:
• The AUDIO button is unavailable for the audio
components other than this receiver.
1 2 3 4
5 6 7 8
9 0 +10
MACRO
M1 M2 M3
Repeat the above steps 1 to 4 for each of
5
your components.
2
4
DEVICE
buttons
0
T/V
ENTER
• If entering is performed successfully, the LED will
flicker twice.
• To be sure that the setup code is correct, press the
POWER(or STANDBY) button.
If your component is tuned off, the setup code is correct.
• When your component is not turned off, repeat the
above steps 2 to 4, trying each code for your component
until you find one that works.
1 2 3 4
Notes:
5 6 7 8 • If the LED did not flicker twice, then repeat the above
steps 3 to 4 and try entering the same code again.
9 0 +10
• Manufacturers may use different setup codes for the
MACRO
same product category. For that reason, it is important
M1 M2 M3
that you check to see if the code you have entered
operates as many controls as possible. If only a few
functions operate, check to see if another code will
work with more buttons.
• When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this receiver.
However, in case of Sherwood DVD player and MD
recorder, aim it at the REMOTE SENSOR on the
corresponding component.
15
T/V
Find the setup codes according to the type
and the brand name of your component,
referring to "Setup Code Table" on page 44.
Enter a 3 digit code, aiming the remote control
at the remote sensor on the component.
Example) When entering "001".
1 2
5 6
0 1
9 0
MACRO
M1 M1 M2 M2
3 4
7 8
+10 +10
M3 M3
1
5
9
M1