ENTERING A SETUP CODE
•
This remote control can control up to ten different components.
•
Before operating audio and video components using the remote control supplied with this receiver, the setup
code for each component should be entered.
•
For system remote control operation, the setup code for each Sherwood component such as CD player, tape
deck and DVD player(V-756, etc.) is "001" respectively. (However, the setup code for some Sherwood DVD
player such as VD-4103, etc. is "112", "114" or "091". Enter each setup code for CD player and tape deck doing
from step ③ as follows.
Turn on the component you want to control.
1
Example) When entering the setup code for this
receiver, turn on this receiver.
■Note:
If you component has the discrete POWER ON and OFF
buttons, please do not turn on the component manually.
Press both the MAIN and ROOM 2(/ENTER)
3
buttons simultaneously for 3 seconds.
OSD
POWER
OFF
MAIN
CH/
SET
VOL
CH
MUTE
AUTO
DSP
7.1
SURR
RETURN
STEREO
1
3
2
4
6
5
7
9
8
DISC
ROOM 2
DISP
0
ENT
MI
M2
M3
RNC-500
Then the setup menu will be displayed on the LCD
screen.
■Note:
If the display of the corresponding mode disappears,
start again from the above step ③ or the current mode.
Select the device corresponding to the
5
component you want to control.
Example) When selecting the AUDIO for
receiver or amplifier, etc.
OSD
OFF
MAIN
ROOM 2
ENT
POWER
14
Find the setup code for your component
2
referring to "Set-Up Code Table" in the
operating manual of this remote control.
Example) The 3 digit setup codes for the Sherwood
"Audio" are 001,024, ...(Hint:The correct
setup code for this receiver is "001".)
Select the Pre-PROgramming mode.
4
OSD
OFF
Then the Pre-PROgramming menu will be displayed.
Select the device from which the appropriate
6
3 digit setup code table will be selected.
Example) If it is the AUDIO code table,
select the AUDIO.
POWER
OSD
OFF
POWER