Sherwood VR-758 User Manual page 21

Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Enter the test tone mode.
8
RC
T.TONE
At each channel, adjust the level as desired
until the sound level of each speaker is
9
heard to be equally loud.
Main unit
ADJUST
Cancel the test tone function.
RC
T.TONE
Adjusting the LFE level
• You can adjust the LFE (Low Frequency Effect) levels included in Dolby Digital and DTS program sources.
• LFE channel is an additional channel exclusively reserved for additional deep bass sound effects of "5.1"
channels, also called the ".1" channel.
Press the CHANNEL SELECTOR button
for more than 2 seconds to enter the LFE
level mode.
Main unit
CH.
SELECTOR
Adjust the level of the selected LFE as
desired.
Main unit
ADJUST
Repeat the above steps 11 and 12 to adjust each LFE level.
RC
ADJUST/CH LEVEL
or
RC
CH SEL.
or
RC
ADJUST/CH LEVEL
or
22
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows :
FRONT-L CENTER FRONT-R
SUBWoofer
• When the speaker setting is "N", the test tone of the
corresponding channel is not available.
• When the SPEAKER button is set to off, the test
tone function cannot work.
• You can select the desired channel and adjust its
level with repeating the steps 5 and 6 in "Adjusting
each channel level" procedure.
• Each time this button is pressed in the LFE level
mode, the LFE level changes and is displayed for
several seconds as follows :
Dolby Digital LFE DTS LFE
• Each time these buttons are pressed, the LFE level
can be adjusted within the range of either -10~0 dB
for Dolby Digital program sources or -10~+10 dB for
DTS program sources.
• In general, we recommend the LFE level to be
adjusted to 0dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the
setting as necessary.
• If the LFE level display disappears, start from the
step 11 again.
SURR R
SURR L