Sherwood VR-758 User Manual page 59

DVD PLAYER
PROBLEM
No playback • The disc is loaded upside down.
• The disc is not playable.
• The disc is dirty.
• The rating level is not set correctly.
• The symbol about invalid operation is displayed.
Malfunction • The disc is scratched or dirty badly.
No picture • The video cords are disconnected.
• The incorrect selection of input source on the TV.
• The disc is not playable.
Noisy or distorted picture • The unit is connected to a VCR directly and the
copyguard function is activated.
• The disc is dirty.
• It is in rapid advance or reverse playback, or in
frame advance playback.
Abnormal or no picture • The component video output signal is not
selected correctly.
Slight pause of picture • The layer transition occurs during playback of
DVD Videos recorded in dual-layer format.
Noise or distorted sound • The disc is dirty.
POSSIBLE CAUSE
60
REMEDY
• Reload the disc with the printed side up.
• Use a playable disc.
• Clean the disc.
• Set the rating level setting correctly.
(Refer to "When selecting the PARENTAL
CONTROL" on page 48.)
• Adjust the setting correctly.
(Refer to "SYMBOL ABOUT INVALID
OPERATION" on page 24.)
• Press the POWER switch to switch the power off,
press the POWER switch again and then unload
the disc.
• Connect the cords correctly.
• Select the input source correctly.
• Use a playable disc.
• Connect the unit so that the picture signal is
transferred directly to the TV.
• Clean the disc.
• Sometimes a small amount of picture distortion
may appear. This is not malfunction.
• Select the component video output signal
correctly.
(Refer to "CHANGING THE COMPONENT
VIDEO OUTPUT SIGNAL" on page 39.)
• Sometimes slight pause may occur.
This is not malfunction.
• Clean the disc