Continued
When VIDEO 1, VIDEO 2, TAPE / MD or AUX / TV is selected
Select the digital or the analog input
desired.
5
Main unit
DIGITAL
INPUTS
Notes :
• When DVD is selected as input source, the digital signals are reproduced automatically without selecting the
signal input.
• When the selected digital input is not connected, no sound will be heard(Refer to "ENJOYING SURROUND
SOUND" on page 20.)
• The sound from the component connected to the selected digital input can be heard regardless of the selected
input source.
• When playing back the program sources with surround sound, refer to "ENJOYING SURROUND SOUND" on
page 20.
Operate the selected component for play back.
6
Adjust the (overall) volume.
7
Main unit
MASTER VOLUME
or
Down
Up
Adjusting the tone (bass and treble)
Select the tone mode as desired
8
Main unit
TONE
MODE
• Each time this button is pressed, the corresponding
input is selected as follows :
OP (tical)1
• To listen to DTS or Dolby Digital program sources in
the 2-CH downmix mode, the digital input must be
selected.(For details, refer to "2 CH downmix mode"
on page 20.)
RC
VOLUME
• Each time this button is pressed, the corresponding
tone mode is selected and shown for several
seconds as follows :
• If the tone display disappears, press the TONE
MODE button again.
• When the tone defeat mode is selected ("TONE
DEFEAT"), bass and treble modes cannot be
selected.
14
OP (tical)2
CO (axial)
BASS
TREBLE
TONE CONTROL
or TONE DEFEAT
AN (alog)