Table of Contents
Advertisement
18. Performing cycle stitching
This sewing machine can perform sewing of plural sewing pattern data in one cycle in the order of the data.
As many as 30 different patterns can be entered. Use this function to sew two or more different buttonholes
on sewing products.
In addition, registration of as many as 20 cycles can be performed. Copy and use the data to fill the needs.
→ Refer to
"V-14. Copying sewing pattern" p.44
(1) Selection of cycle data
1) Set the mode to the input mode.
Under the input mode where SET READY LED
goes out, selection of the cycle data is enabled.
If the current mode is the sewing mode, press
READY key ❷
to the input mode.
Only under the input mode, selection of the cycle
data is enabled.
2) Select cycle stitching data.
Press ITEM SELECT key ❻
which have been registered are changed over and
displayed in order. Cycle data No. and continuous
stitching data No. which have been registered
after the last registered pattern No. are displayed.
Here, select the cycle data No. which you desire
to sew.
3) Perform sewing.
When READY key ❷
the state where the cycle data is selected, SET
READY LED lights up to show that the sewing
is enabled.
Cycle data No. 1 only has been registered at the
time of your purchase. However, sewing status
cannot be obtained since the sewing pattern has
not been inputted. Perform inputting of sewing
pattern referring to (2) Method of editing cycle
data on the next page.
to change over the mode
, and patterns
is pressed in
– 51 –
❷
❻
Advertisement
Table of Contents
