JUKI LBH-1790S Instruction Manual page 43

No.
S021 Pitch at bar-tacking section
This item sets sewing pitch of bar-tacking section.
Top of
Top of
square
round
type
type
Bottom
Bottom
of square
of round
type
type
1st clearance
S022
This item sets the clearance between 1st bar-tacking
and knife groove. This item is applied to all shapes.
2nd clearance
S023
This item sets the clearance between 2nd bar-tack-
ing and knife groove.This item is applied to all
shapes.
Single/double stitching
S031
This item selects single or double stitching.
S032 Double stitching cross selection
This item selects overlapping stitching or cross stitching at the
needle entry of parallel section when setting double stitching.
: Double stitching
Compensation of double stitching width
S033
This item sets amount to narrow overedging width of
1st cycle when setting double stitching.
S034 Number of times of basting
This item sets number of times of basting.
: Without basting
Basting pitch
S035
This item sets pitch at the time of performing basting.
Rolling length of basting
S036
This item sets rolling length of needle thread when
performing basting.
Rolling pitch of basting
S037
This item sets rolling pitch of needle thread when
performing basting.
Rolling width of basting
S038
This item sets rolling width of needle thread when
performing basting.
Lengthwise compensation of needle entry
S039
of basting
This item sets the amount to move needle entry po-
sition back and forth when performing basting more
than two cycles.
*1 : Displayed according to the shape
*2 : Displayed when it is set to with edit. Refer to
*3 : Displayed when the function is selected.
Item
Top of
semilunar
type Bottom of
straight bar-
tacking
Bottom of
semilunar
type
Single Double
stitching stitching
: Cross stitching
: With basting
(Setting of number of times)
"V-12. Method of setting sewing data with/without edit"
Setting range
0.200 to 2.500
Bottom of
taper bar-
tacking
0.0 to 4.0
0.0 to 4.0
–
–
0.0 to 2.0
0 to 9
1.0 to 5.0
2.0 to 20.0
0.2 to 5.0
0.0 to 4.0
0.0 to 2.5
– 40 –
Edit unit Remarks
0.025 mm –
0.1 mm –
0.1 mm –
– –
– *3
0.1 mm *3
1 time –
0.1 mm *3
0.1 mm *3
0.1 mm *3
0.1 mm *3
0.1 mm *2, *3
p.37.