Table of Contents
Advertisement
10. Using the initial value pattern
This sewing machine has the initial value to perform the optimum sewing for the sewing shapes (31 shapes).
→ Refer to
"XI. INITIAL VALUE DATA FOR EACH SHAPE TABLE"
When creating sewing data newly, it is convenient to create it by copying the initial value pattern.
1) Set the mode to the input mode.
Under the input mode where SET READY LED
goes out, pattern change is enabled. If the current
mode is the sewing mode, press READY key ❷
to change over the mode to the input
mode.
2) Call initial value pattern.
The currently-selected pattern No. A is displayed.
Press DATA CHANGE key ❼
initial value pattern
3) Select shape.
The shape selection screen B is displayed to
shown the currently-selected shape C.
Select shape C to sew with DATA CHANGE key
❼
. It is possible to select the shape from
among 12 shapes at the time of your purchase.
However, it is possible to select the shape from
among maximum 31 shapes by increasing the
shape selection level (K004).
→ Refer to
"V-21. Method of changing memory
switch data"
p.55.
4) Perform trial sewing.
Press READY key ❷
the sewing mode. Then it is possible to perform
sewing and the selected shape can be sewn.
* The initial-value pattern can be edited only with respect to the data on needle thread tension and
sewing speed. Be aware that the edited data will return to the initial value(s) when the pattern shape is
changed or re-call of the pattern is carried out.
5) Copy initial value pattern.
Copy the pattern which has been selected and confirmed through the steps above to the normal pattern
and use it.
Copying procedure → Refer to
to select
.
to set the mode to
"V-14. Copying sewing pattern"
p.89.
A
❷
p.44.
– 34 –
2)
B
3)
C
❼
Advertisement
Table of Contents
