I Message Operation - Icom IC-91A Instruction Manual

7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)

I Message operation

D D TX message programming
TX messages are available for up to 6 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
, a to z
ters) (small letters)
A TX message channel "Ch01" must be programmed, if you
want to use the GPS message. The GPS message is trans-
mitted from Ch01 only.
q Enter "TX MESSAGE" in message/position set mode.
➪
MENU screen MESSAGE/POSITION
(Push [MENU/LOCK]) (Rotate [DIAL]
• TX MESSAGE screen is displayed.
wRotate [DIAL] †
to select the desired transmit message
channel.
• Ch01 to Ch06 and OFF are available.
• Previously message is displayed if programmed.
e Push [6/M.N](≈ ≈ ) to select the message edit condition.
• The 1st digit of the message blinks.
TX MESSAGE TX MESSAGE
r
:SET :SET
:BACK :BACK
52
, some symbols and space.
➪
TX MESSAGE
†
, then push [5/SKIP](ï)
Ch01 Ch01
†
:SEL :SEL
:EDIT :EDIT
CLR:CLR CLR:CLR
r Rotate [DIAL]
• Push [3/LOW](A/a) to change the character group from "AB" (al-
phabetical characters; capital letters), "ab" (alphabetical charac-
(capital let-
ters; small letters), "12" (numbers) and " !" " (symbols) in
sequence.
• If un-necessary character is entered, push [6/M.N](≈ ≈ ) or
[4/DUP](Ω Ω ) to select the character, then push [1/SCOPE](CLR)
to erase the selected character, or push and hold
[1/SCOPE](CLR) for 1 sec. to erase following all characters from
the cursor.
tPush [6/M.N](≈ ≈ ) to select 2nd digit, then rotate [DIAL]
select the desired character or code.
†
.)
• Push [6/M.N](≈ ≈ ) to move the cursor right; push [4/DUP](Ω Ω ) to
move the cursor left.
• 2nd digit blinks (1st digit stops blinking).
y Repeat the steps r and t to enter the desired message.
• Up to 20-character message can be set.
u Push [5/SKIP](ï) to store the message.
i Push [MENU/LOCK] to return to frequency indication.
†
to select the desired character or symbol.
TX MESSAGE TX MESSAGE
Ch01 Ch01 ! ' '
r
Hellow!† Hellow!
:SET :SET CLR:CLR CLR:CLR
:SEL :SEL A/a:CHAR A/a:CHAR
:CUR :CUR
†
to