Roland U-8CW Getting Started Manual page 50

Creating Songs with the U-8 and Cakewalk
5
If you choose to apply effects, the EZ RECORDING Mixdown Wizard -
Effect Selection appears. Use the CURSOR buttons or the
VALUE dial to move the cursor, then press the
the effect patch. After making the selection, press the
click Next.
In this example, select the Final RV patch from System Effects.
fig.10-60c.e.eps_50
6
At the EZ RECORDING Mixdown Wizard - Finish and Get Ready to
Mixdown, press the
box.
7
Adjust each track's volume in the U-8 StudioWare Panel.
8
If you have chosen to apply effects, select Console from the View menu to
open the Console window.
9
Check whether the output destination of the tracks you want to apply
effects are set to U-8 WAVE OUT 1 [MASTER], and put on the effect switch
of the tracks.
fig.53-2a
50
NEXT button or click Finish to close the dialog
Effect switch on/off
VALUE
TIME/
ENTER
ENTER button to select
NEXT button or
Keeping the INPUT INST
(mic and guitar input) or
INPUT AUX (auxiliary and
digital input) faders raised
may allow the introduction
of noise into the sound.
During mixdown, either
mute any unused inputs, or
lower the faders for those
inputs.
You can audition the effect-
applied sounds by pressing
the REC MONITOR button
on the U-8 Mixer, and can
adjust the final mix level
while listening the sounds.