Fuser Adjust - Ricoh AP3850C Maintenance Manual

Note
❒ When the toner cartridge is al-
most empty or "Auto Adjust"is
not completed, the following
message appears on the panel
display.
Failed.
Press # To Exit
Press { { { { Enter #} } } } to return to "Main-
tenance", and then repeat the steps
B
from .

Fuser Adjust

When replacing the fusing unit
Note
❒ When "Toner is Almost Empty"
appears on the panel display, re-
place the toner cartridge and per-
form "Auto Adjust", and then
perform the "Fuser Adjust".
Reference
⇒ p.65 "Replacing the Toner Car-
tridge"
⇒ p.22 "Auto Adjust"
A A A A
Keep pressing
"Maintenance" appears.
Maintenance
{ { { { Menu} } } }
until
ZDJS001J
Adjusting the Color Registration
B B B B
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
Color Regist.
No
C C C C
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select "Yes",
and then press { { { { Enter #} } } } .
D D D D
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Fus-
er Adjust At Unit Replace", and
then press { { { { Enter #} } } } .
Fuser Adjust
At Unit Replace
The following message appears on
the panel display.
Print Test Sheet
No
Important
❒ When the toner cartridge is al-
most empty or "Auto Adjust"is
not finished, the following mes-
sage appears on the panel dis-
play and Fuser Adjust is not
available.
Cannot Adjust
See User's Guide
Confirm that the toner cartridge is
installed. The toner cartridge must
be installed. See p.65 "Replacing
the Toner Cartridge".
If the toner cartridge is installed,
perform "Auto Adjust". See p.22
"Auto Adjust".
*
2
*
23