Table of Contents
Advertisement
Replacing Consumables and Maintenance Kit
M M M M
Holding the green handle of the
new Fusing Unit, use your other
hand to push the area right in
front of the handle to create a
slight slant, and then push the
Fusing Unit slowly to the back.
5
Important
❒ Confirm that the Fuser Oil Unit
is facing the inside of the print-
er.
❒ Confirm that the Fusing Unit is
properly positioned in the ma-
chine.
N N N N
Close the upper left cover (A A A A ) and
push the handle (B B B B ) slowly to the
back until it clicks into place.
82
O O O O
If you removed the External Tray
in step
Insert the hooks of the External
Tray into the printer slits, and
lower it toward you.
P P P P
ZDJH050E
If the Duplex Unit is installed,
close the Duplex Reversal Unit.
Reference
See p.64 "Opening and Closing
the Duplex Reversal Unit"
Q Q Q Q
If the 2 Tray Finisher was in-
stalled, reattach the 2 Tray Finish-
er to the printer.
Reference
See p.63 "Detaching the SR770
(2 Tray Finisher)"
R R R R
Plug in the power cable and turn
on the power.
S S S S
Perform fuser adjust.
After replacing the fusing unit, the
following message appears on the
panel display.
ZDJH051J
Adjust Fuser in
Maintenance Menu
you need to perform fuser adjust.
For more information, see p.23
"When replacing the fusing unit".
D D D D
, reattach it to the printer.
ZDJH010J
Advertisement
Table of Contents
