Table of Contents
Advertisement
E Remove the cover and push in
the Photoconductor Unit until
it stops.
I I I I
Lower the inner cover slowly.
J J J J
Tighten two screws using provid-
ed screwdriver.
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the back of the front cov-
er.
K K K K
Turn the light brown lever clock-
wise.
ZDJX702E
L L L L
Close the front cover slowly by
pushing the two areas on the left
and right.
ZDJH018J
M M M M
Plug in the power cable and turn
on the power switch.
The following message appears on
the panel display. The printer
starts calibration. Please wait until
it stops.
Calibrating...
ZDJH019J
Important
❒ Do not turn off the power
switch during calibration to
avoid a printer malfunction.
Replacing the Photoconductor Unit
ZDJH020E
5
ZDJH041J
75
Advertisement
Table of Contents
