Table of Contents
Advertisement
E E E E
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select "Yes",
and then press { { { { Enter #} } } } .
The printer prints the test sheet.
See p.28 "Test Sheet Samples".
F F F F
To make the offset settings, re-
A A A A
D D D D
peat steps
to
when the following message ap-
pears on the panel display.
Print Test Sheet
No
G G G G
Press { { { { Enter #} } } } .
The following massage appears on
the panel display.
Adjustment A
0.0
H H H H
Enter the correct values for A
through L on the test sheet in or-
der.
Note
❒ Confirm the printed Test Sheet
to enter the correction values.
A Use { { { { U U U U } } } } or { { { { T T T T } } } } to enter the
value (-7.0 to +7.0) shown next
to the whitest square, into box
A of the Test Sheet.
Adjustment A
+2.0
Note
❒ Pressing { { { { U U U U } } } } or { { { { T T T T } } } } increas-
es or decreases the value in
0.5 units.
❒ Sometimes, there are two of
the whitest squares next to
each other. For example, if
the two squares of "+1" and
"+2" are the whitest, enter
"+1.5".
and select "No"
*
*
Adjusting the Color Registration
❒ You can adjust the color
alignment for each color in
the range of "-7.0 to +7.0".
❒ There is an area on the Test
Sheet for you to put down
the values of "A" through "L".
B Press { { { { Enter #} } } } .
C Make the settings for "B" to "L"
in the same manner, using
steps A A A A and B B B B .
D When you finish the settings
up to "L", press { { { { Enter #} } } } .
The following message appears
on the panel display.
Maintenance
After a while, "Ready" appears
on the panel display.
2
27
Advertisement
Table of Contents
