Brother DCP-1510 Service Manual page 51

Error code 7D00 Error code 7D00
Jam Inside 3 Jam Inside 3
Remove the jammed paper, then press Start. Remove the jammed paper, then press Start.
When the power switch was turned ON, the eject sensor detected paper pass. When the power switch was turned ON, the eject sensor detected paper pass.
(Cannot determine whether the top cover is open or whether it is a paper jam.) (Cannot determine whether the top cover is open or whether it is a paper jam.)
<User Check> <User Check>
• • Clo
• • Rem
Error code 7E00 Error code 7E00
Jam Tray Jam Tray
Remove the jammed paper from Tray, then press Start. Remove the jammed paper from Tray, then press Start.
Detected that multiple paper is fed five times in a row during receiving fax or printing list/ Detected that multiple paper is fed five times in a row during receiving fax or printing list/
report. report.
<User Check> <User Check>
• • Rem
• • Check tha
• • Check tha
• • Check tha
• • Check tha
• • Flip thro
Close t se the to he top co p cover ver. .
Remove th ove the jamm e jammed pa ed paper per. .
S S t t e e p p C C a a u u s s e e
Eject actuator caught in Eject actuator caught in
1 1
sections of the machine sections of the machine
Paper feed/paper printing Paper feed/paper printing
2 2
position sensor PCB failure position sensor PCB failure
3 3 E E j j e e c c t t s s e e n n s s o o r r f f a a i i l l u u r r e e
4 4 M M a a i i n n P P C C B B f f a a i i l l u u r r e e
Remove th ove the jamm e jammed pa ed paper per. .
Check that the paper is set in the p t the paper is set in the paper tray cor
Check that there is not too muc t there is not too much paper set in the pa
Check that the thickne t the thickness of the paper is wi ss of the paper is within the st
Check that the size o t the size of the pape f the paper is withi
Flip through the pa ugh the paper and res per and reset it in the pa
S S t t e e p p C C a a u u s s e e
1 1 M M a a i i n n P P C C B B f f a a i i l l u u r r e e
1-35 1-35
Reattach the eject actuator. Reattach the eject actuator.
Replace the paper feed/paper printing position Replace the paper feed/paper printing position
sensor PCB ASSY. sensor PCB ASSY.
R R e e p p l l a a c c e e t t h h e e e e j j e e c c t t s s e e n n s s o o r r P P C C B B A A S S S S Y Y . .
R R e e p p l l a a c c e e t t h h e e m m a a i i n n P P C C B B A A S S S S Y Y . .
aper tray correctly rectly. .
h paper set in the paper tray per tray. .
thin the standard andard. .
r is within the stan n the standard. dard.
et it in the paper tray per tray. .
R R e e p p l l a a c c e e t t h h e e m m a a i i n n P P C C B B A A S S S S Y Y . .
Confidential Confidential
R R e e m m e e d d y y
R R e e m m e e d d y y