Brother DCP-1510 Service Manual page 127

7 7 .1 .14 4 F F u u s s e e r r u u n n i i t t
• • Some pa
(1) Rem (1)
(2) (2) Remove t
(3) (3) Releas
(4) (4) Remove th
Side thermistor harness Side thermistor harness
(DCP-16** series, (DCP-16** series,
MFC-19** series only) MFC-19** series only)
Center thermistor harness Center thermistor harness
Heater harness Heater harness
Frame R Frame R
Harness routing: Refer to " Harness routing: Refer to
fuser unit (DCP-15** series without fan, MFC-18** series without fuser unit (DCP-15** series without fan, MFC-18** series without fan)
ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC-18** ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC-18**
series with series with fan)
WARNING: WARNING:
Some parts in rts inside the side the machine machine are extre
hot immediately after the machine is used. hot immediately after the machine is used.
When opening the top cover or back cover to When opening the top cover or
access any parts inside the machine, never access any parts inside the machine, never
touch the shaded parts shown in the touch the shaded parts shown in the
following figures. following figures.
Remove th ove the two ta e two tapti ptite pan B M4 te pan B M4x14 sc
Remove the sponge o he sponge on the frame R n the frame R, and rele
thermistor harness (DCP-16** series, MFC-19** series only) from the securing fixtures. thermistor harness (DCP-16** series, MFC-19** series only) from the securing fixtures.
Note: Note:
• • Once the spo Once the sponge is peele nge is peeled from the side cov
Release the heate e the heater harnes r harness from the se
machine. machine.
Remove the taptite p e taptite pan B M3x8 screw an B M3x8 screw, and remove the ins
Insulation roof Insulation roof
Taptite pan B M4x14 Taptite pan B M4x14
Sponge Sponge
" 1 1 . . Frame R / main PCB ASSY / low voltage power supply PCB unit / Frame R / main PCB ASSY / low voltage power supply PCB unit /
fan)" " and " and " 3. 3. Frame R / main PCB ASSY / Frame R / main PCB ASSY /
2-39 2-39
are extremely mely
back cover to
x14 screw rews. s.
, and release the cen ase the center therm
d from the side cover R, replac er R, replace the sponge wit
s from the securing f curing fixtures ixtures, and remov
, and remove the insulatio
Fig. 2-36 Fig. 2-36
low voltage power supply PCB unit / fuser low voltage power supply PCB unit / fuser
ter thermistor ha istor harness and s rness and side
e the sponge with new one. h new one.
, and remove the fuse e the fuser unit from th r unit from the e
ulation roof from the fus n roof from the fuser unit.
Taptite pan B M3x8 Taptite pan B M3x8
Taptite pan B M4x14 Taptite pan B M4x14
Fuser unit Fuser unit
fan)" " , , " " 2 2 . . Frame R / main PCB Frame R / main
Confidential Confidential
ide
er unit.
PCB