Brother DCP-1510 Service Manual page 117

(2) Remov (2)
(3) Remov (3)
(4) Disco (4)
(5) Releas (5)
Low voltage PCB harness Low voltage PCB harness
Notch Notch
Harness routing: Refer to " Harness routing: Refer to
/ fuser unit (DCP-15** series without fan, MFC-18** series without / fuser unit (DCP-15** series without fan, MFC-18** series without fan)
PCB ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC- PCB ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC-
18** series with 18** series with fan)
/ fuser unit (DCP-16** series, MFC-19** / fuser unit (DCP-16** series, MFC-19** series)
Assembling Note: Assembling Note:
• • When assem
• • After
Remove the screw p e the screw pan (S/P wash an (S/P washer) M3.5
Remove the low e the low volta voltage powe ge power supply
Disconnect the he nnect the heater harn ater harness and th
power supply PCB unit. power supply PCB unit.
Release the h e the hook to ook to remove remove the bu
Rib Rib
Low voltage power Low voltage power
supply PCB unit supply PCB unit
Notch Notch
Screw pan (S/P washer) M3.5x6 Screw pan (S/P washer) M3.5x6
" 1. 1.
fan)" " and " and " 3 3 . .
When assembling the lo bling the low voltag w voltage power supp
PCB with the two ribs of the machine. PCB with the two ribs of the machine.
After the the replac replacement, ement, refer refer to to "4.
SUPPLY PCB UNIT" in chapter SUPPLY PCB UNIT" in chapter 3
2-29 2-29
er) M3.5x6 screw to r x6 screw to release th
r supply PCB unit PCB unit from the from the machine
ess and the low volt e low voltage PCB har age PCB harness from t
the bushing shing from th from the mach e machine.
Heater harness Heater harness
Ground harness Ground harness
Fig. 2-24 Fig. 2-24
Frame R / main PCB ASSY / low voltage power supply PCB unit Frame R / main PCB ASSY / low voltage power supply PCB unit
Frame R / main PCB ASSY / low voltage power supply P Frame R / main PCB ASSY / low voltage power supply
series)" " . .
e power supply PCB unit, enga ly PCB unit, engage the two notch
"4. IF YOU REPLACE THE LOW IF YOU REPLACE THE LOW
3 to configure each setting. to configure each setting.
elease the ground ha e ground harness.
machine. .
ness from the low vol he low voltage
ine.
Rib Rib
Hook Hook
Bushing Bushing
fan)" " , , " " 2 2 . . Frame R / main Frame R / main
ge the two notches of the
VOLT VOLTAGE POWER AGE POWER
Confidential Confidential
rness.
tage
PCB unit CB unit
es of the