Brother DCP-1510 Service Manual page 128

unit (DCP-16** series, MFC-19** series) unit (DCP-16** series, MFC-19** series)
7 7 . . 1 1 5 5 B B a a c c k k c c o o v v e e r r
(1) (1) Remov
(2) Relea (2)
Hook harness Hook harness
(only for models with handset) (only for models with handset)
Harness routing: Refer to " Harness routing: Refer to
Assembling Note: Assembling Note:
• • Connec
Remove the four t e the four taptite bi aptite bind B M4x12 scr
Release the hook h se the hook harness fr arness from the sec
with handset). with handset).
Taptite bind B Taptite bind B
M4x12 M4x12
" 10 10.
Connect the hook harness acco t the hook harness according to the follow
below). Engage the hook harness connector to the groove on the back cover. below). Engage the hook harness connector to the groove on the back cover.
hook harness through the hole "A" of the back hook harness through the hole "A" of the back cover.
around the guide "C" once. around the guide "C" once.
connector from the groove on the back cover. connector from the groove on the back cover.
Hole "D" Hole "D"
Hook harness Hook harness
Back cover Back cover
Guide "B" Guide "B"
. .
2-40 2-40
nd B M4x12 screws to rem ews to remove the ba
om the securing fix uring fixtures of th tures of the back cov
Fig. 2-37 Fig. 2-37
. Hook harness (only for models with handset) (back cover) Hook harness (only for models with handset) (back
rding to the following procedu ing procedures (refer to the figure
cover.
Put it through the hole "D". Put it through the hole "D".
 
Guide "C" Guide "C"
Hole "A" Hole "A"
ove the back cover fr ck cover from the mac om the machine.
e back cover (only fo er (only for models
Taptite bind B M4x12 Taptite bind B M4x12
Back cover Back cover
Taptite bind B Taptite bind B
M4x12 M4x12
res (refer to the figure
 
Hook it to the guide "B". Hook it to the guide "B".
 
Release the hook harness Release the hook harness
 
Groove Groove
Connector Connector
Confidential Confidential
hine.
r models
cover)" " . .
Put the Put the
Loop it Loop it
 