Brother DCP-1510 Service Manual page 122

(3) Remove (3)
(4) (4) Remove
Ground harness Ground harness
Taptite cup S M3x8 SR Taptite cup S M3x8 SR
Taptite cup S M3x8 SR "A" Taptite cup S M3x8 SR "A"
(only for models without modem PCB) (only for models without modem PCB)
Note: Note:
• • There are two kinds of main PCB ins
• • Make sure tha
Assembling Note: Assembling Note:
• • Attac
• • For models wit
• • After
• • Make sure to att
Remove the four (five the four (five for models for models without mo
the ground harness, the main PCB ASSY, and the main PCB insulation sheet from the machine. the ground harness, the main PCB ASSY, and the main PCB insulation sheet from the machine.
Remove the two tap the two taptite bind B M4x tite bind B M4x12 screw
Main PCB insulation sheet Main PCB insulation sheet
(for models with insulation sheet (for models with insulation sheet
on the main PCB USB port) on the main PCB USB port)
Taptite bind B M4x12 Taptite bind B M4x12
Main PCB ASSY Main PCB ASSY
There are two kinds of main PCB insulatio
attached to the main PCB USB port, there is no need to tighten the main PCB insulation attached to the main PCB USB port, there is no need to tighten the main PCB insulation
sheet together with the screw at the bottom of the rear side. sheet together with the screw at the bottom of the rear side.
Make sure that the main PCB ASSY is secu t the main PCB ASSY is secured by screw
disconnecting harnesses and flat cables. disconnecting harnesses and flat cables.
Attach the main PCB insu h the main PCB insulation she
the figure above. the figure above.
For models without ADF hout ADF, secure the main PCB insulat , secure the main PCB insulation sheet and the main PCB ASSY
with the screw "A". with the screw "A".
After the the replace replacement, ment, refer refer to to "1.
to configure each setting. to configure each setting.
Make sure to attach insulation sheet. Failure ach insulation sheet. Failure to attach the
or electrical shock. or electrical shock.
2-34 2-34
without modem PC dem PCB) taptite c B) taptite cup S M3x
12 screws to remove s to remove the main sh
Main PCB Main PCB
insulation sheet insulation sheet
(for models (for models
without insulation without insulation
sheet on the main PCB USB port) sheet on the main PCB USB port)
Fig. 2-31 Fig. 2-31
ulation sheets. For model n sheets. For models with the insulat
red by screws when connec
lation sheet and the main PCB ASSY in the ord et and the main PCB ASSY in the order as shown in
"1. IF YOU REPLACE THE MAIN IF YOU REPLACE THE MAIN
to attach the insulation sheet can
up S M3x8 SR sc 8 SR screws to rem rews to remove
the main shield plate from t ield plate from the machin
For models without For models without
insulation sheet on the insulation sheet on the
main PCB USB port main PCB USB port
Main Main
shield shield
plate plate
or or
Insulation sheet Insulation sheet
For models with For models with
insulation sheet insulation sheet
on the main PCB on the main PCB
USB port USB port
s with the insulation sheet ion sheet
s when connecting or ting or
er as shown in
ion sheet and the main PCB ASSY
PCB ASSY" in chapter 3 PCB ASSY" in chapter
insulation sheet can result in fire result in fire
Confidential Confidential
ove
he machine. e.
3