Brother DCP-1510 Service Manual page 45

Error code 6200 Error code 6200
No Drum No Drum
Open the Scanner Cover and Top Cover, then install the Drum Unit. Open the Scanner Cover and Top Cover, then
Detected that the drum unit was not set by GRID current error. Detected that the drum unit was not set by GRID current error.
<User Check> <User Check>
• • Set th
• • Clean
Electrodes location of the toner cartridge and drum unit Electrodes location of the toner cartridge and drum unit
Electrodes location of the machine Electrodes location of the machine
Set the drum un e drum unit cor it correc rectly tly. .
Clean the el the electrode ectrodes of th s of the drum
S S t t e e p p C C a a u u s s e e
Dirt on the electrodes of the Dirt on the electrodes of the
1 1
drum unit drum unit
Dirt on the high voltage power Dirt on the high voltage power
2 2
supply PCB terminal supply PCB terminal
Connection failure of the high Connection failure of the high
3 3
voltage PCB flat cable voltage PCB flat cable
High voltage power supply PCB High voltage power supply PCB
4 4
failure failure
5 5 M M a a i i n n P P C C B B f f a a i i l l u u r r e e
1-29 1-29
install the Drum Unit.
e drum unit. unit.
Clean the electrodes of the drum unit. Clean the electrodes of the drum unit.
(Refer to the figure below.) (Refer to the figure below.)
Clean the high voltage power supply PCB Clean the high voltage power supply PCB
terminal. (Refer to the figure below.) terminal. (Refer to the figure below.)
Reconnect the high voltage PCB flat cable. Reconnect the high voltage PCB flat cable.
Replace the high voltage power supply PCB Replace the high voltage power supply PCB
ASSY. ASSY.
R R e e p p l l a a c c e e t t h h e e m m a a i i n n P P C C B B A A S S S S Y Y . .
Fig. 1-7 Fig. 1-7
Fig. 1-8 Fig. 1-8
Confidential Confidential
R R e e m m e e d d y y