Brother DCP-1510 Service Manual page 48

Error code 7000 Error code 7000
Jam Inside 1 Jam Inside 1
Open the Scanner Cover and Top Cover, pull out the Drum Unit and remove the Open the Scanner Cover and Top Cover, pull out the Drum Unit and remove the
jammed paper, then press Start. jammed paper, then press
The eject sensor does not detect paper pass after the paper printing position sensor detected The eject sensor does not detect paper pass after the paper printing position sensor detected
the paper pass. the paper pass.
<User Check> <User Check>
• • Rem
• • Check tha
• • Check tha
• • Flip over the p
• • Check tha
• • Flip thro
Remove th ove the jamm e jammed pa ed paper per. .
Check that the paper is set in the p t the paper is set in the paper tray cor
Check that there is not too muc t there is not too much paper set in the pa
Flip over the paper in the pap aper in the paper tray or rotat
Check that the thickne t the thickness of the paper is wi ss of the paper is within the st
Flip through the pa ugh the paper and res per and reset it in the pa
S S t t e e p p C C a a u u s s e e
Foreign object inside the Foreign object inside the
1 1
machine machine
Eject actuator coming off or Eject actuator coming off or
2 2 caught in sections of the caught in sections of the
machine machine
Connection failure of the paper Connection failure of the paper
3 3 feed/paper printing position feed/paper printing position
sensor PCB harness sensor PCB harness
Connection failure of the eject Connection failure of the eject
4 4
sensor PCB harness sensor PCB harness
Paper feed/paper printing Paper feed/paper printing
5 5
position sensor PCB failure position sensor PCB failure
6 6 E E j j e e c c t t s s e e n n s s o o r r f f a a i i l l u u r r e e
7 7 M M a a i i n n P P C C B B f f a a i i l l u u r r e e
1-32 1-32
Start.
aper tray correctly rectly. .
h paper set in the paper tray per tray. .
er tray or rotate the paper 180 deg e the paper 180 degrees.
thin the standard andard. .
et it in the paper tray per tray. .
Remove the foreign object. Remove the foreign object.
Reattach the eject actuator. Reattach the eject actuator.
Reconnect the paper feed/paper printing Reconnect the paper feed/paper printing
position sensor PCB harness. position sensor PCB harness.
Reconnect the eject sensor PCB harness. Reconnect the eject sensor PCB harness.
Replace the paper feed/paper printing position Replace the paper feed/paper printing position
sensor PCB ASSY. sensor PCB ASSY.
R R e e p p l l a a c c e e t t h h e e e e j j e e c c t t s s e e n n s s o o r r P P C C B B A A S S S S Y Y . .
R R e e p p l l a a c c e e t t h h e e m m a a i i n n P P C C B B A A S S S S Y Y . .
Confidential Confidential
rees.
R R e e m m e e d d y y